Eagle 415 FC

For repair of tanks, engine blocks, fabrication of aluminum including cast aluminum.

Use a slightly carburizing flame. Clean all oxides from the weld area with a stainless steel wire brush. Pre-heat material to 1000°F. Melt a 1/4" of the rod on to the work piece. The flux will turn to a liquid and continue heating until the alloy free flows. Continue adding alloy until the weldment has been completed. Allow weld to cool slowly and remove flux with a stiff brush and hot water.

The Eagle 415 FC has an active flux inside the rod. It can be applied in all positions with an oxy-acetylene gas torch.

Slightly Carburizing Flame
Sizes: Inches 1/8
mm 3.25